Not much "done" but I am pecking away at progress.

After fighting with the Vintage Air a bit and their assembly process I was finally able to get it in there in a manner I accepted. I wish it was better, but it will be as good as it gets. I ended up mounting it differently so that I did not have to drill through the smoothed firewall. I installed the dash frame so that I can reference it for wiring and component locations [Fuse box, relay box, ECU, Wideband controller, etc.]



Not much to see here, but I wrapped up the hard parts of the rear brakes. I have yet to tackle the parking brake or hydraulic lines.



The upper control arms I ordered were backordered around 4 weeks and held me up from putting the car on the ground. Regardless I assembled what I had of the front end, Hotchkis lower control arm pivots, strut rods, and sway bar. I have the Hotchkis tie rods ready to go as well.



The power steering bracket I designed was wrapped up as well, so far so good. I was able to use a factory Hemi 6.1L drive belt. I have some interest in the bracket and may sell a few.