Grinding or sanding #3 bearing sides?

Print Thread

Re: Grinding or sanding #3 bearing sides? [Re: maximus] #2207703 12/04/16 06:18 PM 12/04/16 06:18 PM
Joined: Jan 2003 Posts: 1,784 PA W5DART66 top fuel
W5DART66 top fuel Joined: Jan 2003 Posts: 1,784 PA	Yes all the time. Get some fine grit paper on flat surface. Normally it's just some high spots from manufacturer.

Entire Thread
Subject	Posted By	Posted
Grinding or sanding #3 bearing sides?	maximus	12/04/16 09:12 PM
Re: Grinding or sanding #3 bearing sides?	MR_P_BODY	12/04/16 09:29 PM
Re: Grinding or sanding #3 bearing sides?	Cab_Burge	12/06/16 07:09 AM
Re: Grinding or sanding #3 bearing sides?	W5DART66	12/04/16 10:18 PM
Re: Grinding or sanding #3 bearing sides?	R/T1968R/T	12/05/16 12:54 AM
Re: Grinding or sanding #3 bearing sides?	BPE	12/05/16 01:31 AM
Re: Grinding or sanding #3 bearing sides?	maximum entropy	12/05/16 10:27 PM
Re: Grinding or sanding #3 bearing sides?	Al_Alguire	12/05/16 10:34 PM
Re: Grinding or sanding #3 bearing sides?	Anonymous	12/05/16 11:48 PM
Re: Grinding or sanding #3 bearing sides?	polyspheric	12/06/16 03:20 AM
Re: Grinding or sanding #3 bearing sides?	Monte_Smith	12/06/16 04:31 AM
Re: Grinding or sanding #3 bearing sides?	dvw	12/06/16 05:22 AM
Re: Grinding or sanding #3 bearing sides?	dthemi	12/06/16 07:05 AM
Re: Grinding or sanding #3 bearing sides?	FastmOp	12/06/16 07:09 AM

Hop To