"Look no farther than the Factory Service Manual (FSM) for the proper procedure."

What I am asking is not in the FSM

I understand to not tighten various things prior to the car being fully loaded.

The question i have is what "position" do you normally have the fulcrum ( not sure if that is the correct name or description ) portion of the LCA before installing the bar,,,,( does it sit "above, within, below" the LCA housing )

I put a link to a picture that shows the "fulcrum" part i am referring to.... ( obviously it is too high in the picture,,, )

[img]http://phoenixspecialtycoatings.com/uploads/2/8/2/5/2825131/7357573.jpg?408[/img]

I am going to pull the bars out and adjust the fulcrum part of the LCA..
I should be able to figure it out,,,,,

Thx

Last edited by 69CHARGERMD; 06/14/15 03:51 PM.