Quote:

Where is the later year .125 orifice located in the separator plate? I'm wondering if this is one of the holes that Transgo instructs to open up, then you install a .140 orific in the housing. This doesn't make any sense. Even if not modified, why install a plug with a larger hole than the plate.




Yes, Transgo instructs you to enlarge this hole...the thought being it's easier to manipulate the orifice in the case.

In the pic below D is the front clutch feed (3rd gear) and B is the kickdown servo feed (second gear).

8340746-SepPlate.jpg (392 downloads)