Quote:

Sounds like a great build. My question, what cam could I get that will produce close numbers with same combo but low 9-1 comp. Don't want a roller just hyd.




Unfortunately this requires a roller cam, but these are the dyno results for a 451, 9.5:1 compression, ported 452 iron heads, single 950 cfm 4-bbl, Comp Cams XR292R solid roller. The horsepower and torque figures are somewhat comparable to the figures previously discussed. It will give you an idea what may be accomplished with the lower compression. Sorry that I don't have any dyno figures for this combination lower than 3900 rpm, but at that time, I just didn't think to ask the operator to pull it any lower.

rpm....TRQ....HP

3900...547....406
4000...547....416
4100...554....432
4200...573....459
4300...574....470
4400...578....484
4500...586....502
4600...588....515
4700...584....522
4800...567....518
4900...569....530
5000...555....529
5100...556....540
5200...563....557
5300...562....567
5400...550....565
5500...547....573
5600...554....591
5700...549....591
5800...546....602
5900...544....611
6000...537....614
6100...534....621
6200...523....618
6300...507....608
6400...500....609
6500...490....607
6600...481....604
6700...471....601
6800...458....593

Last edited by heyoldguy; 01/02/13 03:19 PM.