I found the old post about my sticky valve. The picture of the disassembled valve is in this thread.
https://board.moparts.org/ubbthreads/show...amp;Search=trueThe problem with mine was the valve assembly on the left side in the picture. It was rusted in the bore from sitting for years. When I tried to remove it, it broke into pieces. I had to find another valve to use for parts. Be careful removing that assembly. If yours is still working, that assembly should come right out.
If it doesn't pull right out, do NOT soak it with PB blaster. It will swell the seal and you'll be looking for another prop valve for parts.
