I'm wondering if there is enough milling to be the problem.
I would check my cam degree first.

Did you check the old pushrods against the new pushrods for length!
really sounds like it is holding the valves open from pushrods too long,

You can buy a shim kit and shim up the rocker shafts .040 then .060 this cannot hurt anything worst it can do is tick.

http://www.hughesengines.com/Index/produ...mp;partid=10406

http://www.hughesengines.com/Index/produ...mp;partid=10404

Last edited by Dodgem; 12/05/12 10:52 AM.