tom:
P1762-GOV PRESS SEN OFFSET VOLTS TOO LO OR HIGH
When Monitored and Set Condition:
P1762-GOV PRESS SEN OFFSET VOLTS TOO LO OR HIGH
When Monitored: Continuously with the key on and the engine running.
Set Condition: This code will set if the governor pressure is out of range in park or neutral
for 1.3 seconds for three consecutive bad 3.0 second tests and sump temp > 10°C (50°F) and
< 127°C (260°F) are required to set the code.
POSSIBLE CAUSES
CHECK FOR OTHER TRANSMISSION DTC’S
POWERTRAIN CONTROL MODULE
INTERMITTENT CONDITION
GOVERNOR PRESSURE SENSOR SIGNAL CIRCUIT SHORT TO VOLTAGE
5-VOLT SUPPLY CIRCUIT SHORT TO SENSOR GROUND
INTERNAL TRANSMISSION PROBLEM
5-VOLT SUPPLY CIRCUIT SHORT TO GROUND
GOVERNOR PRESSURE SENSOR - BELOW 3 PSI
GOVERNOR PRESSURE SENSOR
TEST ACTION APPLICABILITY
1 Turn the ignition on.
With the DRBIIIt, read PCM DTCs.
Is the Good Trip counter for P1762 equal to 0?
All
Yes ! Go To 2
No ! Go To 11
2 Turn the ignition on.
With the DRBIIIt, read PCM DTCs.
Are there any other transmission DTCs present?
All
Yes ! Repair all other transmission DTCs before proceeding. If a
Park/Neutral DTC is present make sure to perform the diagnostics for that first.
Perform TRANSMISSION VERIFICATION TEST VER - 1.
No ! Go To 3
328
T