I need to do my low/rev adj on my race 727 so i need to be sure the snug will work on the adj stud,so that is correct to get it snug?then back it off,lock it down?I cant find a socket to fit it!
Quote:

problem is for 72 inch pounds (6 foot lb) most torque wrenches are junk and way over torque. I heard the only ones that will do it are good needle dial ones.
anyways front band what I call wrist tight (snug) with a 1/4 or 5/16th wrench not hard to get just a nice wrist snug.
Then back front band off 1 3/4 turns if it's too loose it will slip into second.
rear band same but back it off 2 1/4 turns




Last edited by Clanton; 09/18/12 07:11 PM.
GOTBOOST!New improved with Victor heads.
http://www.enginelabs.com/mopar-big-bloc...t-of-necessity/