Mopargnome I have used clecos before but just dont like the fact on drilling holes that are not needed. I normally can make due with what i have but i ordered another twenty clamps last week so i hope that will cover it
Thanks for the compliments guys. I have been moving a little slow since i have been working 60+ Hours a week lately, so be patient.
Anyways i have a little update of the cowl repair. It was quite a bit of work but well worth it to save the original cowl. Tons of pin holes and crusty metal along the front lip and various areas...
The way i went about fixing it was using old floor pans that were scrap, cutting out there beads, and welding them into new metal. Since the floor beads were a little bigger i ground them down to the correct size. I made the parts piece by piece and welded them back it. The long and hard way but, its better than cutting numbers out
