Acceptable rocker arm to pushrod clearance at max lift

Print Thread

Re: Acceptable rocker arm to pushrod clearance [Re: mshred] #1206971 03/31/12 05:28 PM 03/31/12 05:28 PM
Joined: Jun 2003 Posts: 52,972 Romeo MI MR_P_BODY Master
MR_P_BODY Master Joined: Jun 2003 Posts: 52,972 Romeo MI	The spec from Hughes for bottom protrusion underside the rockers is .450" which equals about 2-3 threads sticking out of the adjuster screw give or take a little Yes, I am talking about the OD of the cup, that is all...at max lift the clearance spec is as I mentioned in my original post. So I am just wondering, based on the fact that im not sure what gauge my checking pushrod is (made it out of a junk one my dad found at work last year) if the 3/8" pushrod cup will hit since I only had 5/16" pushrods last year The cup OD will be the same size so you dont have to worry about that if you have clearance now

Entire Thread
Subject	Posted By	Posted
Acceptable rocker arm to pushrod clearance at max lift	mshred	03/31/12 06:45 PM
Re: Acceptable rocker arm to pushrod clearance	HPMike	03/31/12 06:54 PM
Re: Acceptable rocker arm to pushrod clearance	1_WILD_RT	03/31/12 07:01 PM
Re: Acceptable rocker arm to pushrod clearance	mshred	03/31/12 07:19 PM
Re: Acceptable rocker arm to pushrod clearance	MR_P_BODY	03/31/12 08:54 PM
Re: Acceptable rocker arm to pushrod clearance	mshred	03/31/12 09:06 PM
Re: Acceptable rocker arm to pushrod clearance	MR_P_BODY	03/31/12 09:28 PM
Re: Acceptable rocker arm to pushrod clearance	mshred	03/31/12 10:16 PM
Re: Acceptable rocker arm to pushrod clearance	MR_P_BODY	03/31/12 10:20 PM
Re: Acceptable rocker arm to pushrod clearance	mshred	03/31/12 10:33 PM

Hop To