Quote:
I think the problem is the design of the PTC ring gear mount, the previous advice was based on the use of a factory converter.
Removing material in that area on a lathe shouldn't affect the balance.
, Now my PTC 11" didn't have any issues, I'd call Kenny & see whats up, explain the problem, If anything i would just put it on a lathe & trim it down, It shouldn't hurt the balance, your not triming much weight off, plus its a total circle, should not affect anything, If it is the ring placement then you might have starter problems too.
Are you shure the weights aren't bottoming out? If you look i see that it not landing flush on the bace above the ring gear, Can you take a few close-up shots?
Last edited by joedust451; 11/16/11 09:11 PM.