Threads Created By PlumCrazyChris

Threads Created \| All Posts Threads Created By PlumCrazyChris
Title	Forum	Post Time
Will fuel pressure of 50 psi cause problems?	Gen III Hemi Tech	08/26/21 02:41 AM
Will F-Body 4spd pedals,z bar, etc. swap into an 74 A-body?	Moparts Question and Answer	04/18/18 11:21 PM
Trans issues, any advice?	Moparts Question and Answer	03/20/14 01:14 AM
Highest mileage/power engine build	Unlawfl's Race & Engine Tech	11/14/12 10:56 PM
How critical is adjusting shock length with lowered car	Corners Are Best - Handling Tech	11/14/12 10:39 PM
Where do I drill the hole for my HotWire 5.7 harness?	Moparts Question and Answer	05/01/12 07:44 PM
3G Hemi - 727 spacer kit needed?	Moparts Question and Answer	12/13/11 04:32 PM
Anyone trim their 5.7 flexplate to remove the gear ring	Moparts Question and Answer	12/15/08 04:38 AM
Anyone try 6.1 Cherokee manifolds for Hemi conversion	Moparts Question and Answer	12/10/08 07:54 PM
What happened to Dr. Diff's Website	Moparts Question and Answer	11/01/08 07:29 PM
Brake pads for Slider type calipers - anything good?	Moparts Question and Answer	09/25/08 09:26 PM
What does a 5.7 Hemi weigh?	Moparts Question and Answer	09/24/08 07:02 PM
b body 4spd into a e body? What swaps???	Moparts Question and Answer	09/16/08 04:34 AM
Spring rate for factory 318 leaf springs???	Moparts Question and Answer	07/28/08 09:44 PM
Anyone make a 3.73 ratio ring and pinion for the 8 3/4	Moparts Question and Answer	07/01/08 07:37 PM
Difference in length for A body and E body Strut Rods??	Moparts Question and Answer	07/01/08 07:35 PM