1966 B-Body 8-3/4 to Dana 60 - Moparts Forums

Register Log In Moparts Forums Moparts Question and Answer 1966 B-Body 8-3/4 to Dana 60

Print Thread

1966 B-Body 8-3/4 to Dana 60 #967329 04/05/11 10:01 PM 04/05/11 10:01 PM
Joined: Aug 2007 Posts: 34 indiana,usa D donsbelvedere OP member
donsbelvedere OP member D Joined: Aug 2007 Posts: 34 indiana,usa	Hello installed dana 60 in my 1966 B-Body.It had 8 3/4 .How do I measure to or where to properly cut down the drive shaft to fit.Or is there a lenght it will be...Thanks alot Donnie

Re: 1966 B-Body 8-3/4 to Dana 60 [Re: donsbelvedere] #967330 04/05/11 10:09 PM 04/05/11 10:09 PM
Joined: Dec 2004 Posts: 10,554 Rittman Ohio fourgearsavoy I Live Here
fourgearsavoy I Live Here Joined: Dec 2004 Posts: 10,554 Rittman Ohio	I think I seen the measurements for Dana-VS-8 3/4 from axle to pinion in the tech archives Gus 6570590-burnoutpicturegus.JPG (49 downloads) 64 Plymouth Savoy 493 Indy EZ's by Nick at Compu-Flow 5-Speed Richmond faceplate Liberty box Dana 60

Re: 1966 B-Body 8-3/4 to Dana 60 [Re: fourgearsavoy] #967331 04/05/11 10:13 PM 04/05/11 10:13 PM
Joined: Jan 2003 Posts: 3,031 Erda, UT 67Charger master
67Charger master Joined: Jan 2003 Posts: 3,031 Erda, UT	I am pretty sure it needs to be shortened 1 1/8" when going from 8.75 to Dana 60. DrDiff can verify. 11.33 @ 118.46 on motor 10.75 @ 125.35 w/ a little spray Now, high Speed Open Road Racing - Silver State Classic Challenge, Nevada Open Road Challenge, Big Bend Open Road Race Rocky Mountain Race Week 2020, 2022 2.0, Sick Week 2023

Re: 1966 B-Body 8-3/4 to Dana 60 [Re: 67Charger] #967332 04/05/11 10:59 PM 04/05/11 10:59 PM
Joined: Oct 2003 Posts: 2,537 PORT ALBERNI , BC., CANADA superwrench master
superwrench master Joined: Oct 2003 Posts: 2,537 PORT ALBERNI , BC., CANADA	Quote: I am pretty sure it needs to be shortened 1 1/8" when going from 8.75 to Dana 60. DrDiff can verify. That's what I calculated when I was doing mine.

Moderated by Al_Alguire, Hotwheelsjr, moparts, not_a_charger, RangerDan440, tboomer

Hop To

Powered by UBB.threads™ PHP Forum Software 7.7.1