Years ago my Demon tail panel stripe was placed too low. Is it possible to move it? How? Thanks

Good Lookin Demon! I always liked YELLOW! I don't know to much about the stripes on a Demon but it looks like the trunk key cylinder is centered in the top part of the stripe. If you were to raise it would that be correct? At any rate I think your into it another stripe, I don't think you can remove it and reuse it now.

A heatgun or hairdryer can be used to loosen the adhesive up enough to pull it off.

I don't see how it could be removed without stretching the vinyl so I'd just order up a new one. Even if you could get it off without wrecking it I doubt it would stick as well going on the 2nd time.

nice demon,hair dryer,plus patients,but you are buying a new stripe,second option,it probably bothers you more,doubt most even notice

Last demon stripe kit I got was 2 pieces. Your existing upper piece looks correct, but the lower piece should have been raised up for proper spacing around tailight etc. I've seen the 2 piece kit installed with the end tabs butted together, and then stripes don't end up close enough to taillights and looks silly.

No you cannot move/save the old one.