Working on my combination. 1969 Super Bee with column shift automatic. 400 B block with Indy EZ's. Nick wants to run 2" or even 2 1/8" headers. TTI book says no with fitment. Does anyone have any experiences or advice? I'm planning on calling TTI direct. Thanks guys!

Not sure about your combo, but I have a '69 road runner w/ an Indy SR headed 440 in it. I have the TTI 2" to 2 1/8" step headers (for the raised ports) on it and it works w/ the factory column shifter.

I run the factory column shifter on my 68 Dart,440 with E-heads.TTI 2" headers. Works fine after working with the linkage at the shift rod on the trans.Seems that I flipped the rod over.I use a reverse Turbo action valve body also.Maybe not quite the same setup as yor B Body.

I run the 1 7/8 headers on my 71 cuda. TTI sold the linkage that goes over the header so I could still use the column shifter.

TTI said my 2 1/8th step headers would'nt clear the colum shifter linkage , got them anyway , only clearance issues was the pass side header just touching rear of block , this was on a set of 572-13s , TTI have to cover themselves.