I've been posting this on the HAMB, since I've been on there seeing how others have done it. I sectioned my car 2", and will be chopping the top next. The doors I peeled back the skin, sectioned the center, replaced the skin, and cut the remainder off the bottom. Fender looks good, will have some hammer and dolly work, only took 2" out because I still wanted some steel between the top of the wheel arch and top of the fender. Lots of spot welds!

http://www.jalopyjournal.com/forum/showthread.php?t=430749

Heres the doors, before and after.

is this a "slope back" ? what are your plans for it? custom,gasser, or ?????? that was a good way to section your door. what do you plan to do on the body ? lookin good !

wow very kool,a lot of work,cant wait to see more,,,

wow very kool.a lot of work cant wait to see more on this build

Started bracing the car and I chopped it 3". Hard part is going to be forming a piece to fit behind the rear window, as I had to move it froward to look right, couldn't just lay it down.

hard to tell from the pic,, did you move the entire roof forward or just the rear glass section ?

I chopped the roof 3" and then had to move the rear window forward to get the right roofline.

kool cant wait to see more on this build

Started filling in around the window.

sorta looks like a 48-50 merc window laying down like that ,,your work looks great,,

Nice job!

Got some more work on it, all welds are done and ground around the window, lot of hammer and dolly work. I couldn't grind the welds down enough so you can still see them. Don't know how some guys can weld and finish their metal so much you can't see the welds. Need to finish the firewall and rockers next.

another view

looking great,, how about a pic from the front over all

Hope to make some room in my garage and roll it out soon. Then I'll put the hood back on and see how it looks.

cant wait to see it

Looking great Andy, I am very impressed! Give me a call sometime. I'd love to catch up.

Snows gone, rolled it out to get a better view. Not sure if I should have chopped more. Its 5" shorter overall between the section and chop.

No, it's spot-on!