915 Head Flow Results
#458436
09/03/09 04:47 PM
09/03/09 04:47 PM
|
Joined: Oct 2003
Posts: 3,698 NE Oklahoma
Von
OP
master
|
OP
master
Joined: Oct 2003
Posts: 3,698
NE Oklahoma
|
Had my set of 915s flowed. I bought these a few months ago from a member who had bought them from another member. Dont know who ported them. Here are the #s I .100 67.3 .200 137.9 .300 210.4 .400 264.3 .500 265 .600 270 E .100 47.6 .200 101.9 .300 134.6 .400 179.8 .500 198.3 .600 211.5 They were flowed at 28'' with a 4.280 bore. I dont know if the exhaust had a pipe or not. Anything stand out or look funny on the numbers? Would the flow #s change much when used with a 4.375 fixture? If so, more or less, usually? I'll have some numbers to compare as they are flowing my BS heads that were ported by Dwayne. Thanks
72 RR, Pump gas 440, 452s, 3800 lbs, Corked, ET Radials,. 11.33@117.72.
Same car, bone stock 346s, 9.5 comp, baby solid. 12.24@110.
|
|
|
Re: 915 Head Flow Results
[Re: JohnRR]
#458438
09/04/09 10:27 AM
09/04/09 10:27 AM
|
Joined: Jul 2004
Posts: 19,318 State of confusion
Thumperdart
I Live Here
|
I Live Here
Joined: Jul 2004
Posts: 19,318
State of confusion
|
I`m no expert but those look like some descent numbers and if I remember right, my Ed Vickroy ported 906`s went 278-279 intake and low 200`s on the exhaust and pushed my dart to 10.40`s at will in my daily driver till they cracked.
72 Dart 470 n/a BB stroker street car `THUMPER`...Check me out on FB Dominic Thumper for videos and lots of carb pics......760-900-3895.....
|
|
|
Re: 915 Head Flow Results
[Re: Robbins]
#458441
09/05/09 12:15 PM
09/05/09 12:15 PM
|
Joined: Oct 2003
Posts: 3,698 NE Oklahoma
Von
OP
master
|
OP
master
Joined: Oct 2003
Posts: 3,698
NE Oklahoma
|
Quote:
Did you have them cc'd on the chamber side?
They were supposed to, but didnt.
Im gonna pull my 452s off and have them flowed also and will have both sets cc'd.
72 RR, Pump gas 440, 452s, 3800 lbs, Corked, ET Radials,. 11.33@117.72.
Same car, bone stock 346s, 9.5 comp, baby solid. 12.24@110.
|
|
|
|
|