I have a 452 (400-with 440 crank) stroker engine with mopar stage 6 heads-(stock) and a comp cam -270 duration with 470 lift with headers and it has two Edelbrock 650 CFM thunderseries carbs on it.
I want to know waht I should use for primary and secondary jetting and also what metering rods and the step up springs should I use?????

The carbs are stock calabration;

Primary Jets-.095

Secondary Jets .098

Metering rods .068 x .047

with orange step up springs

You can post here or send me an e-mail to; glr7069@ptd.net

Hemi guys? racers? anyone know?????

You might do better asking in the Unlawful race only area. Those guys don't always get here.

Thanks!..
I put a post in there,
But I find it hard to beleave that no one has dual four barrels on there steet car.

My advice it put it together and go drive it. It could be close.

Well, I would rather find out what the calabration should be and that way I won't damage anything

For my 440 I went to one of the old mopar performance guides and used the jets suggested for the 2X4 super stock cars. I'm on the road so I don't have the numbers with me but if you PM me I'll look them up and send them to you when I get home this weekend.

I'd probably put them on as is and go from there. They will need adjusting no matter what you do. It also has a lot to do w/ the rest of your set-up, compression, stall gear, headers??? and so on.

Dan Dvorack sells a device for balancing two-four barrel set ups. I've never seen one in person.