General Kinetics Hyd. Cam Specs - Moparts Forums

Register Log In Moparts Forums Unlawfl's Race & Engine Tech General Kinetics Hyd. Cam Specs

Print Thread

General Kinetics Hyd. Cam Specs #2497717 05/18/18 10:39 PM 05/18/18 10:39 PM
Joined: Feb 2005 Posts: 720 Indiana C Cuda_Mike OP super stock
Cuda_Mike OP super stock C Joined: Feb 2005 Posts: 720 Indiana	Stripped out a 400 today for sonic check, had a GK cam, A5H304-Z hydraulic cam, anyone know specs on it? Thanks for any info. Last edited by Cuda_Mike; 05/18/18 10:45 PM.

Re: General Kinetics Hyd. Cam Specs [Re: Cuda_Mike] #2498168 05/20/18 11:48 AM 05/20/18 11:48 AM
Joined: Feb 2005 Posts: 720 Indiana C Cuda_Mike OP super stock
Cuda_Mike OP super stock C Joined: Feb 2005 Posts: 720 Indiana	Bump

Re: General Kinetics Hyd. Cam Specs [Re: Cuda_Mike] #2498205 05/20/18 01:24 PM 05/20/18 01:24 PM
Joined: Jun 2008 Posts: 3,916 usa L lewtot184 master
lewtot184 master L Joined: Jun 2008 Posts: 3,916 usa	measure the lobe lift and then go over to the crane master lobe profile site and see if anything matches up to 304.

Re: General Kinetics Hyd. Cam Specs [Re: Cuda_Mike] #2498210 05/20/18 01:32 PM 05/20/18 01:32 PM
Joined: Feb 2005 Posts: 720 Indiana C Cuda_Mike OP super stock
Cuda_Mike OP super stock C Joined: Feb 2005 Posts: 720 Indiana	Did the measurement, .332, before I posted, like to know more.

Re: General Kinetics Hyd. Cam Specs [Re: Cuda_Mike] #2498245 05/20/18 02:31 PM 05/20/18 02:31 PM
Joined: Jun 2008 Posts: 3,916 usa L lewtot184 master
lewtot184 master L Joined: Jun 2008 Posts: 3,916 usa	i found a 304/.336. 304 degrees at .004". crane Z lobes.

Moderated by Al_Alguire, Hotwheelsjr, moparts, not_a_charger, RangerDan440, tboomer

Hop To

Powered by UBB.threads™ PHP Forum Software 7.7.1