|
Re: Body Sheet Metal
[Re: DAYCLONA]
#1715254
12/25/14 03:00 PM
12/25/14 03:00 PM
|
Joined: Jan 2004
Posts: 755 Tempe, AZ
loco340cuda
super stock
|
super stock
Joined: Jan 2004
Posts: 755
Tempe, AZ
|
I ordered a door skin for my Cuda' from Classic Industries (talked to the guy over the phone) and asked if it was an AMD part and he said it was a Classic Industries panel and did not know who made it. A week later the door skin shows up in a Classic Industries box. I pulled it out of the box and the skin had the standard AMD label on it, so it turned out to be an AMD panel. I'm not sure this is always the case with sheet metal from them but it was for the part I ordered. It can't hurt to call and ask, you might get a sales person who knows more then the guy I talked too.
70 Cuda 340 4 speed - now stroked to 416ci (SOLD) 2017 Mustang Shelby GT350
|
|
|
Re: Body Sheet Metal
[Re: Lawn Monkey]
#1715256
12/25/14 04:34 PM
12/25/14 04:34 PM
|
Joined: Dec 2007
Posts: 18,160 Mass
DAYCLONA
I Live Here
|
I Live Here
Joined: Dec 2007
Posts: 18,160
Mass
|
Quote:
Is being AMD sheet metal a good thing or not so good thing?
The Majority of AMD panels are nice replacement parts, there are some pcs/panels that have issues that will not be addressed by AMD as the tooling is done, and further investment is not viable in redesigning/correcting the part...your best posting on a forum and asking for input from those that have used the panel/parts in question as to their fit/finish and required remedies
...there will be the usual "dog pilers" that only voice what they have heard, rather than what they've experienced firsthand, and there's also the Ebay crowd that unknowingly buys "seconds" from bulk buyers...basically rejected panels from the mfg, I usually buy directly from AMD or from some of the Moparts AMD sellers to avoid any issues
Mike
|
|
|
Re: Body Sheet Metal
[Re: DAYCLONA]
#1715257
12/25/14 04:42 PM
12/25/14 04:42 PM
|
Joined: Dec 2006
Posts: 714 USA
Lawn Monkey
super stock
|
super stock
Joined: Dec 2006
Posts: 714
USA
|
Quote:
Quote:
Is being AMD sheet metal a good thing or not so good thing?
The Majority of AMD panels are nice replacement parts, there are some pcs/panels that have issues that will not be addressed by AMD as the tooling is done, and further investment is not viable in redesigning/correcting the part...your best posting on a forum and asking for input from those that have used the panel/parts in question as to their fit/finish and required remedies
...there will be the usual "dog pilers" that only voice what they have heard, rather than what they've experienced firsthand, and there's also the Ebay crowd that unknowingly buys "seconds" from bulk buyers...basically rejected panels from the mfg, I usually buy directly from AMD or from some of the Moparts AMD sellers to avoid any issues
Mike
Thanks , I'll buy right from the source (AMD) lucky me I only need a 4 speed hump all other panels are in nice shape.
|
|
|
|
|
|