Removing rear seat from early B 'vert - Moparts Forums

Register Log In Moparts Forums Moparts Question and Answer Removing rear seat from early B 'vert

Print Thread

Removing rear seat from early B 'vert #1709404 12/11/14 02:01 PM 12/11/14 02:01 PM
Joined: Aug 2003 Posts: 1,978 Moncton, New Brunswick hemidart1 OP top fuel
hemidart1 OP top fuel Joined: Aug 2003 Posts: 1,978 Moncton, New Brunswick	I am looking to paint the rear armrest panels on my '65 Belvedere convertible. I am guessing I have to take out the rear seat to get at the screws holding the panels on. Any trick to this? thanks in advance. Al. 1967 Hemi GTX 1969 Chrysler 300

Re: Removing rear seat from early B 'vert [Re: hemidart1] #1709405 12/11/14 02:09 PM 12/11/14 02:09 PM
Joined: Oct 2006 Posts: 3,054 USA B b54406barrel master
b54406barrel master B Joined: Oct 2006 Posts: 3,054 USA	Been a few years since I re-upholstered my '63. Lower seat on mine was the standard push back & lift. Think the back was two 1/4 or 5/16" bolts & then just slide up off the crossbrace.

Re: Removing rear seat from early B 'vert [Re: b54406barrel] #1709406 12/11/14 02:17 PM 12/11/14 02:17 PM
Joined: Feb 2003 Posts: 8,671 A Andrewh master
Andrewh master A Joined: Feb 2003 Posts: 8,671	it is the standard push back and lift. the top of the seat has 2 bolts behind the bottom to remove, then if you look there are 2 hooks on the back of the top of the seat as well. there were only 2 screws holding in each side panel as I recall. but it has been a while since I pulled mine. maybe 3. one was in near where to top rests when it is open.

Re: Removing rear seat from early B 'vert [Re: Andrewh] #1709407 12/11/14 02:37 PM 12/11/14 02:37 PM
Joined: Aug 2003 Posts: 1,978 Moncton, New Brunswick hemidart1 OP top fuel
hemidart1 OP top fuel Joined: Aug 2003 Posts: 1,978 Moncton, New Brunswick	thanks! 1967 Hemi GTX 1969 Chrysler 300

Moderated by Al_Alguire, Hotwheelsjr, moparts, not_a_charger, RangerDan440, tboomer

Hop To

Powered by UBB.threads™ PHP Forum Software 7.7.1