518 sensor plug?

Print Thread

518 sensor plug? #1690767 10/26/14 01:05 PM 10/26/14 01:05 PM
Joined: May 2005 Posts: 4,719 Florida BDW OP master
BDW OP master Joined: May 2005 Posts: 4,719 Florida	My 518 has a cut out at the top of the bell housing. Since I'm not using this, is there plug or recommended way to fill the spot? Or should I just cover it up with duct tape and forget about it?

Re: 518 sensor plug? [Re: BDW] #1690768 10/26/14 02:25 PM 10/26/14 02:25 PM
Joined: Jun 2003 Posts: 441 yellow70charger mopar
yellow70charger mopar Joined: Jun 2003 Posts: 441	If is crank position hole bothers you put. a piece a of ducktape on the inside and mounting face fill with jb weld when it hardens remove tape and sand down the top to fit the profile of the bell.

Hop To