My question is, I want to run my stage VI mopar performance heads and a blower. From my underdtanding there is no blower intake that will fit it properly. I have some spacer place, but do i need my blower intake modified to fit the stage VI heads, or is there a blower intake made for this setup?

Are you running the Chapman Stage VI heads on an RB block?, if so a Max Wedge port blower manifold should be the likely candidate, if you have the heads on a B motor, nothing available that I know of...I don't have my RB (440) blower manifold here for measurements, but I don't think there's enough meat around the ports to open them up to MW/Stage VI specs...Might want to try Indy to see if they have a blower manifold, I assume old-school 6-71/8-71?

do you have the standard 440 port heads or the MW port heads ??

This really would work better in the "race" section.

What Stage VI heads are they? I know you said MP but that doesn't help that much.

Some Stage VI heads were cast to allow use of a 440 intake on a 383, then you had to use the spacers to use a 440 intake on a 440. But I seem to remember they also had some Stage VI heads that were straight replacements for the 440.

Also, although I'm assuming you're talking about a 440 or other RB, what engine are you talking about?

R.