|
Spacer for crank pulley???
#1196221
03/13/12 03:48 AM
03/13/12 03:48 AM
|
Joined: Dec 2005
Posts: 41 Tucson, AZ
moparjimm
OP
member
|
OP
member
Joined: Dec 2005
Posts: 41
Tucson, AZ
|
Here's the deal, I'm using a motor plate, so I need to bring my bottom pulley out 3/4" to align with the fan pulley. The total required distance from the balancer to the center of the groove is 2 1/2", can I use a spacer(3/4") too make up the difference? Is there a pulley out there that would work better. The 2 groove billet ones are 2.00/2.85 to center of the grooves. Any ideas??? I thought about using a wheel spacer, the kind w/o studs, would this work? I prefer to use a single groove if at all possible. Thanks Jim
|
|
|
Re: Spacer for crank pulley???
[Re: 451Mopar]
#1196224
03/13/12 04:34 AM
03/13/12 04:34 AM
|
Joined: Jan 2004
Posts: 27,347 Today? Who Knows?
1_WILD_RT
Management Trainee
|
Management Trainee
Joined: Jan 2004
Posts: 27,347
Today? Who Knows?
|
Normally when using a motor plate sandwiched between the water pump housing & the block the water pump housing gets milled down the thickness of the plate...
"The Armies of our ancestors were lucky, in that they were not trailed by a second army of pencil pushers."
|
|
|
|
|
|