Quote:

Disconnect the rods from either the tranny or shifter before inserting a 1/4" dia rod into the alignment hole on the shifter arms, that will allow you to align all 3 arms together,....chances are you also have shifter stops on the shifter body, perhaps those are misadjusted also, back them out when performing the netural shifter adjustment

Mike



I already did that...like I said my alignment tool will only go through 1/2 and 3/4 so it does align those two levers but it doesnt even pass through the reverse shifter lever in order to get that one in alignment also...in other words it only aligns 2 arms.

I have an extra Hurst shifter on my bench top and it is the same way. Does the reverse shift lever not have to be aligned?

Last edited by Blakcharger440; 02/20/11 02:21 PM.