Quote:

Ari- are those drag radials or bias slicks?

Did you trim the quarter panel wheel well in the front and back or just the front lower corner? Curious as I have my axle centered in the wheel well, hoping to fit the same tire in a bias ply without having to do any trimming! M/T advertised roll out of 93 inches.

Steve




Steve , there bias slicks


rolled the wheel well in and cut the front lowwer quarter till it was flush with the wheel well tub


on the rigth side , back , lowwer quater panel I also did trim it 3/8 of a inch


seen an impression on the slick and it did burn the paint off

1.39 9.85 - 137 mph