If any of these mopar graphics have transfer paper on them use it to your advantage.

Tape the decal exactly where you want it to land. Use the top 1" or so to apply the tape. Try and keep the tape off your graphic if possible.

Fold the decal up over itself. Use a corner of tape or a helping hand to hold it up off the car.

Wet the car body.

Peel the backing paper off.

Carefully start squeegying the graphic from the top down. Don't let ANY of the decal touch the car unless you have used the squeegy to push it down. If you like wrinkles or bubbles ignore this part.

Once it's on carefully pull the transfer paper off while watching for any signs of corners lifting. If your solution was a little too soapy or you didn't press down hard enough this may happen in spots. Don't panic. Just use the squeegy to iron it back down and then try pulling the paper back off again.

Stand back and pat yourself on the back for not having to pay somebody for something you CAN do yourself.