Already made the custom engine mounts for the 440 in my 1949 Wayfarer, and just want to check on a few things before I start welding. The engine is offset 1 1/2" for the steering, set the car for ride height, engine is level side to side, and carb is level, engine drops 4 deg for this? Anyways, question is on the offset. Using a 8 3/4" rear, and didn't realize they were that off center to the right. Not exact #'s, but if the front of the engine is 1 1/2" to the right, the rearend is 3" to the right, should I make the rear of the trans 2 1/4" to the right, and split the difference, and how huge of a deal is this, as long as I get the pinion angles right?