Quote:

You can make 900hp with the MP heads and correct port work. Modern Cylinder head built A 572 Hemi with 15:1 compression MP heads with this port work and made 780lb-ft and 920hp peak tq at about 5500 and peak hp about 7000. This was with fully ported MP Cross Ram and 950 HP carbs.
Chip on this board has a 3800 lbs street trim Cuda running pump gas and these same heads runs 9.50's in the 1/4.
Here is some flow data from my heads.
These are the newer Edelbrock castings, and you not need to worry about quality issue's like the older stuff, but they need checked out anyways.


sounds familiar