Quote:

i believe undecked the pistons will sit about .015 in the hole so undecked i would be at .055 quench, is that still a good thing or is it too wide?
i apretiate all you guys helping me this far or id be asking alot dumber questions

At .055" you have lost virtually all of your quench. You would want to mockup the short block & measure your deck height as the actual dimentions will not be the same as the nominal dimention that is listed for a part & could be anywhere then machine the decks and or the piston quench pads to get the CR and proper quench distance that you want/need. thats why I am full floating my RB rods (steel on steel) so I can easily dissassemble & machine as needed. there are no dumb questions only rude answers. Fire away, this is a free site.

live every 24 hour block of time like it's your last day on earth