Unless you send them back to the same guy to flow them with the
2.05 valves, you are going to be very disappointed. I can tell from
your flow sheet.

2.02" valve is capable of flowing at least 324 CFM @ .700"

2.05" valve is OK in an Edelbrock head but, you won't see any
improvement unless the valve job on 2.02" seat was no good
to begin with.


This is a set I did with the valves listed:

...........INTAKE........................ EXHAUST

.100"_____64.1___________________54.6
.200"____131.6__________________118.6
.300"____194.4__________________158.6
.400"____242.5__________________177.1
.500"____270.8__________________192.4
.550"____279.3__________________199.5
.600"____282.2__________________204.4

2.055" IN x 1.600" EX