Have it angle milled for outlet to tuck more to block then remove the outlet, weld in a 2-1/2” pipe with a flange. Accurate made one like that a few years back, worked nice. Might need a shield over factory starter.
I just sold my Accurate manifold for $1000 last year as I was never going to use it. Not sure if I have a picture of it available... Edit:: found a picture...
Last edited by Rhinodart; 02/08/2407:46 PM.
The funny thing about science is that if you change one miniscule parameter you change the entire outcome to the way you want it.