Quote:

OK, so here are the valve covers and manifold that I decided to use, the non EGR older one.

I also found this in my parts stash, its an Edelbrock carb. has the numbers #1407 on the side and looks like 0236???? any idea what CFM this is and why wont this work on here??? Its obviously too low and hits the manifold on the side. Can a spacer be used to lift it???

And I know the engine is not original, but what valve covers appear more original for this truck??? I painted and sand blasted both sets.

Dave


Dave



Way too much square-bore CFM for your 318! You would only need either a 500 or 600 cfm square-bore or an 800 cfm T.Q., David.