Quote:

---

Quote:

---

Blankets hold heat,cause premature wear

Blankets get all cruddy /dirty easy

Blankets don't cover enough area

Blankets are hard to get the straps from dragging on the ground

Blankets burn up on headers easy

Thats just a few reasons, My sheild was a KIND of hard to get to fit though

Some seem to be able to get them on easy mine , no bueno

---

1)use the proper trans cooler.
2)both wil get cruddy/dirty
3)just need a full coverage blanket!
4)you can cut or tuck straps out of the way.
5)i use header wrap.salution is dependent on aplication of vehicle.
6)that is what you get for buying a shield.

---

Hmmm ..
well, do you use a down comforter in the summer time on your bed ? You have air in house I would guess right ?

shields do not get dirty, sopped with fluid, dirt
One quick rinse with brake cleaner its right back to like new condition, try that with a blanket

since when do they make a blanket that covers the bellhousing area ?

Sure cut the straps off , next time you try to install it , get it right back to the same spot so they fit .. good one

Sure , use header wrap, good idea, hold heat in headers and dirt, etc and then they are shot too

Mine did not fit the tunnel because I moved my motor back or it would have


Done with the topic , not going to argue

look at 99% of super gas or super comp cars

No one runs blankets that I've seen

That my two cents . moving on