Here's the one I plan to bracket race....Quick77R/T built the shortblock
360+.030 roller block
11:1
Eddie closed chamber Heads...bowl blend, Good VJ and open the pushrod pinch to .980 (per RyanJ's recommendation)
Hydraulic Roller 236/240@.050 ..554/.540 lift 112 centers, 107ICL
1.6I 1.5E rockers
Performer RPM...minor porting
830 annular Holley
1 3/4 headers
904 Lock-up w/Shift kit
3200 stall 10" converter
* 3/4" b body rear, 4.10 gear
28" x 10.5" slick
Should be similar to a few others here like Ademon's. A basic, reliable, powerful, nice combo.
Looking to go consistent 7.50's in the 1/8th in a 1992 Daihatsu Rocky that weighs ~2950 lbs w/me in it. 87" wheelbase so that's why I spread the lobe centers and oversized the carb to kill a off idle and little midrange (shiftpoint) torque to make it more tractible until I get a handle on how to make it go rounds. I may go to a single plane if it still has too much torque off the line or a Vac secondary if it goes a little too quick. I figure it should make ~425 (well probably a good bit more
)by ~6000rpm pretty easily.
