That's some nice looking quality work. I like how the bottoms are done vs like the offset W2 stands which are flat as you know. I don't know how anyone would expect them not to take a lot of work to set them up correctly.
If you can post it whats the spring height and are they longer then delived valves? I don't know BB specs but just wondering.
Thanks for the compliments guys!
The engine builder was shooting for a 2.00" installed height, and the valves were Ferrea and REV. The customer bought the heads CNC ported bare from Hughes, so the valves are the builders choice. I don't think they are much longer, if any, than stock Edelbrocks, because he he still needed that deep retainer to get the 2.00". I only moved the rockers to where they needed to be to get the proper geometry.
