I have a set of Strange 35 spline axles that had a
full spline width twist in the splined end right out
from the spool.. they were still working but I changed
them out only because I had another set of them.. I
paint a white line down the whole length of each axle
just to monitor the twist... the stock 8 3/4 that I
first started out with had stock axles... they had
just over a full twist in the length.. they didnt
break either but I knew it wasnt gonna be to long
for them... but then I blew the cap off the center
and thats when I changed to the alum center and the
good parts.. that was right at 600 passes on the stock
8 3/4 with 1.24-1.26 60'