Quote:
Quote:
I sell Pro Comps that are cnc ported that have a 2.20 int and 1.88 exhaust that will flow 350cfm. They are made in Australia but CNC ported and assembled in the USA. They go for $2100 and are a better casting than alot of US stuff.
Does Pro-Comp sponsor anything or any racers?
If I was selling a product, I would put it on a few cars
and made sure I could back up what I say , like,
(a better casting than a lot of US stuff.)
Doesn't sound like to many people heard of them,
or would use them.
They are on a some cars and a lot of test has been done. As far as a better castings goes, I have seen over 50 sets CNC ported without being porous and they are a good hard casting.
Doug
MOPAR or NO CAR!!!
1965 Dodge Coronet soon a 6.1 Hemi with a Magnson blower 810 hp on pump gas
1964 Dodge Polara 582" Indy alum Block 426-1RA heads,
1933 Plymouth PE all Steel, LT1 4L60E
1959 Plymouth Savoy 33,000 mile survivor
Old cars are never done. They are ongoing projects!
| 
