Quote:

---

Quote:

---

That first picture was after taking .004 off the deck. In this one you can see more clearly where the Roloc disc dug in a little harder. Obviously the blue spots are the LOW spots.

---

IMO, The pics arent proving your point. I see very large Uniform Diameter impression marks of different depths in the first two pics.

Evidence of a bad hand rolex disc clean up would be less uniform and sporatic.

In your First pic, the Cylinder tops are untouched by your first shave but the deck clearly shows a wide diameter pattern impression. On the Second cut the "one cylinder" shows the same pattern of the wide diameter cutting impression that the Deck shows on the First cut.

---

The low/blue area at the immediate edge of the cylinders, could have been caused from too much grinding with a cookie, but those marks on the outside edges of the deck surface were made with something large in diameter..possibly an older Blockmaster with dull cutters and too fast of travel speed.