Quote:

If you're gonna bolt and run tham anyway, why not go Magnums? They'll do better than the 302s, are more plentiful, and I would think will be cheaper. Patrick on here has a few sources for mild factory and Engine quest done sets cheap. You'll have to replace the lifters and pushrods too.. but that's not a big deal.



Magnum heads would be the best choice.

They flow more then any other head in storck form.

The close chamber will increase compression.

The cost of the mag. head would be the same or close to any toher small block head. but when you factor in a different intake the correct lifters and pushrods for the oiling of th magnum heads you will be spending more.

If you have the money or time to save up some coin the magnum heads are a the best choice IMO.