Quote: mine came with a shorter arm that could fit on but it does not have the D-slot to aline it on the VB shaft.
maybe that could be clamped tight after the shifter cable is installed and both shifter and trans in N detent.
like I siad,i get to the point you are at. i can get it to either up shift correct and not down shift. or down shift correct but not up shift correctly.
if you seem to think a short arm moveing the cable end in closer to the trans case will work maybe I will swap the arm out on mine and try 1 more time.
Mike, it is quite frustrating to say the least; it should be a fool proof setup to perform as advertised, but not the case in our cases. I'll drive it tomorrow and see what happens; I am not looking for it to be OK on both ends.
