Quote:

I set it at zero at the top. The way it was explained, deflection to to the right of zero was negative and to the left of zero was positive. All of my deflections were to the right. As the tech in the video explained (and assuming he is correct), I would need to move the bellhousing downward to get it within tolerances.


Set your dial indicator at 0 on the left or right, the use it to tell you what you are off on top and bottom, the opposite of your 0 should be within .002ish from 0. How is it for parallel? You need it flat first befor you indicate the hole. Tim

1941 Taylorcraft
1968 Charger
1994 Wrangler
1998 Wrangler
2008 Kia Rio
2017 Jetta

I didn't do 4 years and 9 months of Graduate School to be called Mister!