Look down in the center top below the rotor and locate the clip. You'll see 2 vertical legs. Spread them a bit wider several times with your narrowest pair of needle nose pliers. You wont be able to expand them much. then grab either of the vertical legs and whip it around and up and out in the direction that expands the clip all in one motion. You'll need a thin brass washer of the right dimentions (Ace hardware has a good selection) and use it to reduce the axial play then set the clip back down in there & compress the 2 vertical legs. You dont have much room to compress them much but if some of the horizontle circle of the clip is under the nub it will hold it in place. Try compressing it a half dozen times till you make some progress.
live every 24 hour block of time like it's your last day on earth
