|
|
Re: Sealing pinhole in aluminum heads
[Re: super451b]
#1208328
04/03/12 08:48 PM
04/03/12 08:48 PM
|
Joined: Mar 2006
Posts: 9,910
Eighty Four, PA
B G Racing
master
|
master
Joined: Mar 2006
Posts: 9,910
Eighty Four, PA
|
Quote:
Quote:
I saved this post from speed talk after reading it just in case I had one that I couldn't weld up. http://speedtalk.com/forum/viewtopic.php?f=15&t=26040
Thats why I asked about alternatives to welding. The hole is in a very tough spot to get to , at least with the equipment that I have. It's right where the port floor starts to transition into the short side radius. I have everything here, that I would need , to try the seal-all.
Cost is also a factor. The plant that I worked at closed last fall and I havent been able to find anything that comes close to what I was making before, so my race car budget is substantially less than it used to be. 
Wade,bring it buy the shop and we will take a look at it and try to fix it for you,no charge  
|
|
|
|
|
|
|
