W9 valve train question? - Moparts Forums

Register Log In Moparts Forums Unlawfl's Race & Engine Tech W9 valve train question?

Print Thread

Re: W9 valve train question? [Re: tubtar] #1176986 02/12/12 02:41 PM 02/12/12 02:41 PM
Joined: Dec 2010 Posts: 243 United States W W9 Dart OP enthusiast
W9 Dart OP enthusiast W Joined: Dec 2010 Posts: 243 United States	Quote: What I am reading from Ryan is 5/16ths pushrods and no offset on the lifters for the 59 degree block. With the cam you have selected , you shouldn't be over springing things and a stiff 5/16ths pushrod should be O.K. But I am learning as I go with these things too. If I knew then what I know now. Right the I'm thinking the push rod should be at least .080 thick?

Entire Thread
Subject	Posted By	Posted
W9 valve train question?	W9 Dart	02/12/12 03:59 PM
Re: W9 valve train question?	mafo	02/12/12 04:08 PM
Re: W9 valve train question?	W9 Dart	02/12/12 04:11 PM
Re: W9 valve train question?	W9 Dart	02/12/12 04:49 PM
Re: W9 valve train question?	cbarracuda	02/12/12 05:06 PM
Re: W9 valve train question?	rickraw	02/12/12 04:50 PM
Re: W9 valve train question?	1Fast340	02/12/12 05:07 PM
Re: W9 valve train question?	W9 Dart	02/12/12 05:24 PM
Re: W9 valve train question?	1Fast340	02/12/12 05:29 PM
Re: W9 valve train question?	W9 Dart	02/12/12 05:37 PM
Re: W9 valve train question?	cbarracuda	02/12/12 05:53 PM
Re: W9 valve train question?	mafo	02/12/12 05:56 PM
Re: W9 valve train question?	tubtar	02/12/12 06:22 PM
Re: W9 valve train question?	W9 Dart	02/12/12 06:41 PM
Re: W9 valve train question?	dusturbd340W5	02/12/12 06:47 PM
Re: W9 valve train question?	CompWedgeEngines	02/12/12 08:55 PM
Re: W9 valve train question?	W9 Dart	02/12/12 09:00 PM
Re: W9 valve train question?	tubtar	02/13/12 12:32 AM
Re: W9 valve train question?	W9 Dart	02/13/12 12:36 AM

Moderated by Al_Alguire, Hotwheelsjr, moparts, not_a_charger, RangerDan440, tboomer

Hop To

Powered by UBB.threads™ PHP Forum Software 7.7.1