|
Re: How would you go about fixing this hack job?
[Re: Morty426]
#1054229
08/18/11 09:47 PM
08/18/11 09:47 PM
|
Joined: Oct 2003
Posts: 21,345 Marysville, O-H-I-O
70Cuda383
Too Many Posts
|
Too Many Posts
Joined: Oct 2003
Posts: 21,345
Marysville, O-H-I-O
|
Quote:
Original metal, installs itself and cleans the shop after it's done.
well then... original metal sounds like it's worth the added cost then!
that's it, I'm only buying original metal from now on!!!
honestly, my only experience so far with ANY replacement metal -- aftermarket, NOS, original, etc. is the goodmark half piece trunk floors, which I did a complete amature hack job installing. sure, part of it might have been the panels were "off" but 99% of it was the installer.
I've learned a thing or 2 since then, and this quarter panel is going MUCH better so far. --however, I still have the floor/quarter extensions to put in yet though, and I can tell that those are not quite right...not terrible either though. work-able.
**Photobucket sucks**
|
|
|
|
|
|