I need to put my heater cables back in the car, but they seem way two long. How do you route them? Thanks

someone must have looked under their dash and seen where the cables loop or run. Thanks for reading this.

Maybe you can figure it out from one or more photos from this other forum?
http://a12mopar.com/yabb/YaBB.pl?num=1198135980

I don't remember it being a huge puzzle, but then the ones I reinstalled might not have been run right either.

BTW - it looks like we both registered on the same day - weird eh?

Thanks, I will see if I can just run them and make sure that they do not bind. It just seemed like there was a lot of cable to go where it goes

I had a similar problem....factor service manual has a great diagram showing cable routing.

I have the fsm and can not find where it is in there that shows the routing. Could you send me in the right direction. Thanks