Well, I've tried several routes so far and not found the correct seals for the division bar. Has anyone seen a similar setup to what's in the picture on any other cars and/or know where I can get the right stuff? The car in question is a 65 Polara 500. It's a two piece setup, separate seals on the inside and outside of the glass frame and it slides into a channel that's about 3/16" wide and the upper lips are ~ 1/16" from the backside.
Thanks for any help,
Mike

Bump

That was my best guess too, but nope.. I figure it's gonna be a real long shot - I even tracked down some NOS ones and they're nothing like what's in there.
Thanks though,
Mike

One more shot - I got one out so it's easier to see the shape. I also talked to the guys at Layson's at Farmington last week who suggested possible crossover with other makes, so in that vein who are good suppliers for "the other guys"?
Thanks again,
Mike

Last go round, hate to put it back together with the old crap in there but if I wait too long I'll forget how it goes.
Mike
For giggles, this is what it's for.

she's a beauty!

might want to ask at the:
c-body dry dock,
A web site that deals specifically with c-bodies.