i am trying to get the engine harness on my 70 cuda. not showing very good pics in the fsm. anyone have some pics of the engine out of the vehicle with the engine harness in the correct place? or in vehicle if you can see it clearly? also is the dist hold down left plated and not painted? thanks moparts

the dist hold down is plated - clear cad.

thanks, any pics of the engine wiring harness??

no one has any pics of there engine in or out of there cars???

Manual or automatic?

manuel, with power steering, thanks

Mike,

What part of the harness? The engine harness is two pieces. Both are pretty simple. The front half - start at the temp sender, the harness is held in the looms on the passenger side valve cover. The back half - start at the oil pressure switch and it's held in the looms on the fire wall.

M

the front harness. it looks really tight at all connections? i have no pics to tell if i am routing it right. it was a 383 car when i started and cloning the hemi. just wanted to try to get as much together as possible to not have to lean over the fenders anymore than possible.

Here are a couple of pictures of Dave Waldens (ECS) Hemicuda.

2

3

4

can't see it real well, but does the harness run down the outside of the valve cover then?

Yes it runs on the outside.

On a 70-71 Hemi the PCV valve is on the drivers side, just like in the photo.

after close examination on all the pics, i have not got the right harness! it is packaged 70-71 hemi ebody! from year one, but it looks like a small block harness. i knew i wasn't crazy, but never restored a hemi and wasn't sure if it was right? thanks for all the help, i have got to get it straightened out with year one!! thanks moparts